This website contains adult material and is only suitable for those 19 years or older. Click Enter only if you are at least 19 years of age.or Exit
No Surprise, You Want It, We Make It.
Super big replaceable deck, so easy to build; hidden sealing ring and innovative juice flow control system can significantly solve the leaking problem; patented swivel-cap design makes top-filling as easy as it gets; and side airflow slots direct-to-coil design, you can enjoy a strong and open draw like RDA!
Aye, we've done this TF-RDTA for you.
Creatively added RDA’s airflow system to Rebuildable Tank Atomizer, TF-RDTA puts side airflow slots directly to coils to produce massive clouds of vapor so that you can enjoy a strong and open draw like RDA!
By making the deck & base two in one, TF-RDTA has increased the available tank space to provide more juice.
So you can enjoy the TF-RDTA without having to refill as often.
With 1 6mm in diameter, the deck space has increased by 30 percent (compared with the TF-RCA deck) and be more convenient to build. In addition, the replaceable deck is more economic and cost-effective!
For clearomizer or rebuildable atomizer, no leaking is a top-priority task. TF-RDTA has more compact body and excellent sealing performance by using hidden sealing ring. Along with the innovative juice flow control system, you can close the juice flow slots before filling or replacing deck to prevent leaking.
TFV4 classic swivel-cap design makes top-filling as easy as it gets.
The drip tip with double-layered structure has been improved on the inner layer of glass to avoid scalding.
1 .Before starting make sure your hands are clean.
2.Taking the TF-RDTA S2 deck apart.
3.Installing the pre-wrapped coil.
Insert one end of your coil into the left-side holes, and the other end into the right-side holes.
4.Positioning and cutting the exceeding ends of wire off. Make sure the coil is fixed and lined up with the air hole, and also make sure the coil is NOT touching the deck. Then cut the exceeding ends of wire off.
5.Cutting a strip of cotton and make sure it’s just larger than the coil you built.
6.Inserting the cotton, and placing it in the middle.
7.Then guide the ends of cotton wick through the holes below.
8.Cutting the ends and make sure it’s not too short and not too long.
9.Wet the coil with your e-liquid and adjust the wick.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.